Installed Sound Products

Advantages of a True 3Way System

	Drivers: 2" mid and 1" high frequency coaxial drivers in one common horn, 15" woofer
	Very flat frequency response from 70 Hz to 20 kHz (without controller!)
	Exeptional low distortion
	Very high sound pressure (135 dB SPL at 1 m)
	Reduced Doppler effect at important mid frequency range
	Reproduction up to 20 kHz without partial oscillations
	Rated power / absolute maximum power 650 / 1500 W

Optimized Sound Dispersion

	Precise sound directivity from 700 Hz with large 2" horn
	Ideal angle of dispersion (45° x 45°) for midthrow applications
	Perfect sound coverage when clustering
	No acoustic interference due to coaxial design of HF and midrange drivers

Two Operational Modes

	Full range operation with built in passive crossover
	Selection switch for passive or active operation
	2 way (low/mid-high) active operation with digital controllers Pro C 24 or Pro C 28
	Reliable protection circuitry for MF and HF drivers

State-of-the-Art Driver Technology of 15" woofer

	Extra strong die-cast aluminum basket
	Rear vented voice coil design for minimal power compression
	Minimum LF distortion through extremely long excursion
	Surface coatet cone meaning: reduced distortion high internal damping wheather resistance

Advantages of a 2"/1" Coaxial Design vs. One 2" or 1.5" Drive

	Lower LF frequency of midrange driver (700 Hz)
	Higher HF frequency of tweeter (20 kHz)
	Higher sound pressure levels and better continuous load capacity
	Less distortion

Intelligent Enclosure Design

	Flexible flying point mounting with ANCRA-JUNGFALK fittings
	No limitation for high stacking with flying points on sides
	Special enclosure design ensures minimum horizontal distance between clustered loudspeakers
	Homogeneous baffle design without diffraction edges
	Large rounded bass reflex ports avoiding air noises
	Sturdy metal grill protecting drivers, with option of acoustic foam behind or in front of grill
	Built in steel stand fitting, 35 mm
	Other colors optional, on request
	Front dimensions of enclosure same as subwoofer Pro X Sub L

Acoustical
Principle, Direct Radiation, Bassreflex	3-way, passive, active
Sensitivity in 1 m with 1 W	100 dB SPL
Free field frequency response, passive (internal x-over)	70 Hz - 20 kHz ± 3 dB
Free field frequency response, with controler	60 Hz - 20 kHz ± 2.5 dB
Nominal power handling	650 W
Max. power handling	1500 W
Max. SPL in 1 m, 180 ms sinewave burst	135 dB SPL
Directivity, horizontal x vertical (-6 dB)	45° x 45°
Directivity, above	800 Hz
Electrical
Impedance	8 Ohms
Crossover, passive (internal x-over)	700 Hz, 18 dB/oct
Crossover, active (with controller modul)	700 Hz, 24 dB/oct
Protection circuit, passive	Multifuse for tweeter
Protection circuit, active	Limiter
Mechanical
Material	18 mm birch multiplex
Cabinet Surface	Painted finish
Color standard	Anthracite (RAL 7021)
Special (add-on price)	On request
Handles	2
Stand flange	On bottom
Dampening material	Sheep´s wool
Baffle cover	Dent-proof grille, acoustic foam inside or outside
Terminals	2 x SPEAKON; Input: passive 1 +/-, aktive 1 +/- Mid/High, 2+/- Low; Through
Switch, active/passive	2 x switches
Drivers	Coated cone, weather proof
Woofer	15" long excursion die cast chassis
Tweeter	2"/1" Coax driver
Mounting points	2 x ANCRA JUNGFALK flight rails on sides, 1 x ANCRA JUNGFALK flight rails on rear
Height x width x depth	827 x 430 x 430 mm / 32.5" x 16.9" x 16.9"
Wheigt	48 kg / 105.8 lbs
Recommended controllers	Pro C 28, Pro C 24
Recommended amplifiers	Pro A 2000
Recommended subwoofer	Pro X Sub L
Accessories	On a floor stand LH 15 + LH 28 LH 15 + LH 29 LH 15 + LH 48 + K&M stand 26790 and 26795 LH 36 + LH 28 LH 36 + LH 48 + K&M stand 26790 and 26795 LH 36 + LH 29 On a subwoofer LH 15 + LH 37 LH 36 + LH 37 On a wall LH 15 + LH 43 LH 15 + LH 47 + LH 45 LH 36 + LH 47 + LH 45 Off a ceiling LH 15 + LH 43 LH 15 + LH 47 + LH 43 LH 15 + LH 47 + LH 46 LH 36 + LH 47 + LH 43 LH 36 + LH 47 + LH 46 Off a lighting or truss bar LH 25 + LH 29 LH 26 + LH 29 Other accessories LRH X 15